注蒸汽热采,cyclical steam stimulation
1)cyclical steam stimulation注蒸汽热采
1.Enhancing development efficiency of conve-ntional reservoir bycyclical steam stimulation;稀油油藏注蒸汽热采提高开采效果
英文短句/例句
1.A Coupled T-H-M Model with Applications to Steam Injection in Heavy Oil Reservoir稠油注蒸汽热采中热-流-变形耦合模拟分析
2.Casing Strength Theoretical and Experimental Study of Thermal Recovery Steam Injection Wells;注蒸汽热采井套管强度理论与试验研究
3.The Research of Steam Injection and Hot-water Injection in Cao Tai Buried Hill Construction Cracks High-condensate Oilfield曹台潜山裂缝性高凝油藏注蒸汽及注热水开采适应性研究
4.Power-Heat-Set:Heat-setting for carpet yarn--overheated steam or saturated steamPower-Heat-Set:地毯丝热定型——采用过热蒸汽或饱和蒸汽
5.Study of the Omnidistance Heat Losses and Optimization of Injected Steam Parameters in Steam Drive;蒸汽驱全程热损及注汽参数优选研究
6.Injected Steam Heat Loss and Production Rate of SAGD;蒸汽辅助重力驱注蒸汽热损失及产量预测
7.Perforations for Steam Flood Injecion-production Thick Oil Wells in Liaohe Oilfield辽河油田稠油蒸汽驱注采井射孔方式
8.The calculation model of steam distribution for thermal recovery of heavy oil reservoirs using multilateral wells稠油热采多分支井蒸汽分配计算模型
9.Application of Steam Thermal Recovery Technique in Daqing-Sabei Oilfield蒸汽热采技术在大庆萨北油田的应用
10.The heat source may be steam, heat conduction oil, electricity or coal (oil) hot air furnace.热源可采用蒸汽、导热油、电或燃煤(油)热风炉配套。
11.The drying is performed by hot air heated by steam. The air flow is 4000~5000m3/h.干燥器采用蒸汽加热的热风,风量4000~5000m3/h。
12.Energy-conservation of the Residual Heat of the Flue Gas in a heavy-oil heating recovery steam injection boiler稠油热采注汽锅炉烟气余热回收利用
13.Research on Enhanced Oil Recovery by Solvent System with Steam Injection in Heavy Oil Reservoir;稠油注蒸汽过程中溶剂体系提高采收率的研究
14.Orthogonal Numerical Test of Injection and Production Parameter Optimization of Steam Flooding in Heavy Oil Reservoirs稠油油藏蒸汽驱注采参数优化的正交数值试验
15.cooker, steam-heated, non-domestic蒸汽加热蒸煮器,非家用
16.The Amending Exploitation Effect Research of the Heat Picking Dense Oil Oil Store in Swallow and Spit Phase;热采稠油油藏蒸汽吞吐阶段改善开发效果研究
17.Orthogonal Design for Parameters of Thermodynamic Production by Steam Gorge and Disgorge in Thick Oil Deposit;稠油油田蒸汽吞吐热采参数的正交设计
18.Calculating first interface micro-annulus width during steam stimulation in thermal recovery well热采井蒸汽吞吐过程形成的一界面微间隙计算
相关短句/例句
steam stimulation蒸汽热采
3)steam injection注汽热采
1.Advances in downhole catalytic upgrading of heavy oil understeam injection conditions;注汽热采条件下稠油井下催化改质的研究进展
4)steam injection production注蒸汽开采
1.The basic characteristics of Caonan ultra - heavy oil reservoir, discusses that water sensitivity, alkali sensitivity and temperature sensitivity damage reservoir in the course ofsteam injection production are analyzed in the paper and corresponding technology of reservoir protection is presented.分析了草南超稠油油藏的储层基本特征,探讨了该油藏在注蒸汽开采过程中水敏性、碱敏性、温敏性对储层的伤害,并提出了相应的储层保护技术。
5)steam injection recovery注蒸汽采油
6)superheated steam injection注过热蒸汽
1.The technique ofsuperheated steam injection in steam -assisted gravity drainage;蒸汽辅助重力泄油中注过热蒸汽技术研究
延伸阅读
再热蒸汽系统再热蒸汽系统reheating steam systemzolre zhengq一x一tong再热燕汽系统(reheating steam system)汽轮机高压缸的排汽返回锅炉再热器再热后送回汽轮机中压缸的燕汽管道系统。若采用二级再热，则还应包括中压缸排汽再热后返回低压缸的燕汽管道系统。从汽轮机高压缸(或中压缸)排汽口到锅炉再热器进口的蒸汽管道，称为低温再热蒸汽管道;从再热器出口到中压缸(或低压缸)的燕汽管道，称为高温再热蒸汽管道.低温再热蒸汽温度较低，管道材料通常采用优质碳素钢;高温再热燕汽温度一般与主蒸汽温度相同或略高，管道材料采用耐热合金钢。燕汽在再热系统中的流动阻力对循环热效率的影响较大，每增加0.1 MPa的流动阻力，循环热效率将降低。.2%~。.3%.增大再热蒸汽管道和再热器的管径，虽可降低再热系统的流动阻力，但增加管道和设备的投资费用。所以，再热燕汽系统(包括锅炉再热器)的流动阻力一般限定在高压缸排汽压力的8纬~10%。火电厂设计中，为降低再热燕汽管道的投资，通常采用提高高温再热蒸汽管道蒸汽流速的方法来减小管径，以降低耐热合金钢管材的消耗量;高温再热蒸汽管道因减小管径而增加的压力损失，可以用增大低温再热燕汽管道管径以减少压力损失来补偿。再热燕汽系统压力损失给定后，高温再热蒸汽管道和低温再热蒸汽管道的管径应通过优化计算来确定。
