1)thin-wall pipe pile薄壁管桩
1.Numerical analysis of behavior ofthin-wall pipe pile under lateral load in layered soil;成层地基中薄壁管桩水平承载性状数值分析
2.Performance of cast-in-situ concretethin-wall pipe pile composite foundation under road embankment;路堤下现浇薄壁管桩复合地基工作特性分析
3.Simplified analysis of performance of in-situ concretethin-wall pipe piles;现浇混凝土薄壁管桩单桩性状简化分析
1.Application of Vibration Cast-in-place Concrete Thin-walled Pipe Pile to Mollisol Ground振动沉模现浇混凝土薄壁管桩处理软土地基
2.Dynamical Analysis of the Cast-in-situ Concrete Thin-wall Pipe Pile Composite Foundation;现浇混凝土薄壁管桩复合地基动力特性分析
3.Field Study on the Cast-in-situ Concrete Thin-wall Pipe Pile Composite Foundation;现浇混凝土薄壁管桩复合地基现场试验研究
4.Research on Behaviour of Cast-in-situ Concrete Thin Wall Pipe Pile under Lateral Load;现浇混凝土薄壁管桩水平承载性状试验研究
5.Application of Concrete Thin Wall Pipe Pile to the Deep Base Pit Support;混凝土薄壁管桩在深基坑支护中的应用
6.Construction Technique of PCC Pile振动沉模大直径现浇薄壁管桩施工工艺
7.Construction Control Measures of Thin-wall Pipe Pile by Using Cast-in-place Concrete in South Nanjing Station of Beijing-Shanghai High-speed Railway京沪高铁南京南站现浇薄壁管桩施工控制措施
8.Analytical solution in frequency domain of dynamic response of thin-wall pipe piles with variable wave impedance under low strain transient concentrated load低应变下变阻抗薄壁管桩动力响应频域解析解
9.The comparison of sprinkling concrete thin wall tube pile with normal groundtreatment in soft soil现浇混凝土薄壁管桩与常规软基处理方法比较
10.Study on Pile-soil Stress Ratio and Load Transfer Characteristics of Cast-in-situ Concrete Thin Wall Pipe Pile Composite Foundation;现浇混凝土薄壁管桩复合地基桩土应力比及荷载传递特性研究
11.Study on the Material Experiment and the Bearing Mechanism of Cast-in-situ Steel-slag Concrete Thin-wall Pipe Pile;现浇钢渣混凝土薄壁管桩材料试验与单桩承载特性研究
12.TESTS ON EXCESS PORE WATER PRESSURE INDUCED BY DRIVING GROUP PRESTRESSED TUBULAR CONCRETE PILES预应力薄壁管桩群桩施工引起的超静孔隙水压力试验研究
13.Test Study on Properties of Negative Skin Friction of Thin-wall Pipe Pile Using Cast-in-situ Concrete现浇混凝土薄壁管桩负摩阻力特性试验研究与分析
14.Test Study on Behaviors of Cast-in-situ Concrete Thin-wall Pipe Pile under Lateral Load;现浇混凝土薄壁管桩水平受力特性试验研究与分析
15.Study on the Mechanism and Settlement Computation Method of the Cast-in-situ Concrete Thin-wall Pipe Pile Composite Foundation;现浇混凝土薄壁管桩加固软基机理和沉降计算方法研究
16.Field test on pore water pressure induced by PTC pile installation in soft ground预应力薄壁管桩施工引起的孔隙水压力试验研究
17.Review of Connecting Ways of Steel Thin-walled Sonic-testing Tubes for Concrete Bored Piles混凝土灌注桩用钢薄壁声测管的连接方法
18.Analysis on Settlement of Single Large-diameter Cast-in-situ Tubular Pile;大直径现浇混凝土薄壁筒桩单桩沉降计算分析
相关短句/例句
thin wall pipe pile薄壁管桩
bining the project example, the paper introduces the new technology of consolidation of soft soil foundation of high fill embankment by using the composite foundation ofthin wall pipe pile.结合工程实例介绍采用薄壁管桩复合地基加固高路堤软土地基的新技术。
3)pipe pile with thin wall薄壁管桩法
4)large-diameter thin-wall tubular pile大直径薄壁管桩
5)cast-in-situ concrete thin-wall pipe pile现浇薄壁管桩
1.Analysis of bearing performance of composite foundation withcast-in-situ concrete thin-wall pipe piles under vertical loads;现浇薄壁管桩复合地基竖向承载特性分析
2.The construction process and load-bearing characteristics ofcast-in-situ concrete thin-wall pipe piles have been analyzed based on their application in soft soil improvement of Yan-Tong Expressway.结合现浇薄壁管桩在盐通高速公路软基加固中的应用,对管桩施工方法和承载特性进行了分析研究,并进行了小应变测试、静载荷试验和现场开挖等检测分析。
6)cast-in-place thin-wall pipe pile现浇薄壁管桩
1.In combination with a soft ground project,which was improved bycast-in-place thin-wall pipe piles,the influence of vibration during piling was analyzed,and the method for reasonable evaluation of the vibration effect of piling ofcast-in-place thin-wall pipe piles was discussed.介绍现浇薄壁管桩成桩振动的特点和评价方法。
延伸阅读
超薄壁管生产超薄壁管生产production of ultrathin-wall tubeehaobaobiguan shengehan超薄壁管生产(produetion of ultrathin一walltube)超薄壁管是指直径与壁厚之比在100以上的管材。超薄壁管主要用作弹性元件波纹管的坯料或换热管坯料等。它的生产方法有冷轧、冷拔和旋压等方法。札制法一般生产率较高，尺寸精度高，表面质量好，广为采用。1954年苏联研制的多辊式冷轧管机适于轧制超薄壁管，在这种轧机上，可以轧制最小壁厚0.03mm的管材。在多辊冷轧管机上轧制超薄壁管的关键有3点:(l)减径量不能过大，LD一30一般小于lmm，LD一15小于0.smm;(2)轧辊开口角不能过大，否则会出现轧出的管子呈竹节状;如果开口角过小，会出现棱面，影响管子精度;(3)轧制成品道次管材不能过硬，即在成品前道次应该退火。用冷拔管法生产超薄壁管时，一般均采用超声波振动(见超声波振动拔管)，无超声波振动拔管生产的管子直径与壁厚之比不超过50，而带超声波振动时可达500。(邢维基李连诗)
